Entering The "Fs20 Rsu" Into The Address System; A) Assigning Additional Addresses/Address Types; B) Deleting Addresses/Address Types - Conrad FS20 RSU Bedienungsanleitung

9. Entering the "FS20 RSU" into the FS20 Adress System
The address assignment of the FS20 wireless switching system allows you to assign the "FS20
RSU" to its address system with individual addresses, function groups, local and global
masters. A detailed layout of the address system is included in the operating instructions of
each transmitter of the FS20 system.

a) Assigning Additional Addresses/Address Types

Within the address system of the FS20 system up to 4 address types can be assigned to the
"FS20 RSU". It is thus possible to remotely control the control unit with different transmitters
using the same or different address types. Detailed information concerning the address
system is included in the operating instructions of each remote control of the system.
In order to assign several address types to the "FS20 RSU", repeat the programming described
in Chapter 7.a). The control unit can store a list of up to four addresses or address types.

b) Deleting Addresses/Address Types

• To delete a receiver channel from the list in the memory, set the device to programming mode
and hold down the buttons assigned to this control unit on the respective remote control for
more than 0.4 seconds.
• Then programming mode will be exited automatically and the channel is no longer in the
address list of the roller shutter control unit.
24