Programming And Operation; A) Programming The Receiver Channel; B) Operation; Using The Remote Control - Conrad FS20 RSU Bedienungsanleitung

7. Programming and Operation

All programming is saved in the device and is blackout-protected so that even after a longer
period without power no re-programming is required.

Please note:
There is a factory set 0.5 second delay for all switching procedures which cause
a change in the motor rotation. This avoids any direct switching of motor
direction and any resulting damages.

a) Programming the Receiver Channel

• Press the "retract" button connected to the "FS20 RSU" for at least 5 seconds.
• As soon as the roller shutter is rolled out, the programming mode is active for 1 minute.
• Now press a button for the desired channel on the remote control. If the roller shutter now
retracts, the receiver channel has been saved and the programming of the address is
complete.
• If required, the set programming can be replaced with another button on the remote control
or another remote control channel. Proceed as described above.

b) Operation

Using the Remote Control

Retracting: Briefly pressing the right button of the channel programmed for the roller shutter
control, the roller shutter will be retracted.
Rolling out: Pressing the left button rolls the roller shutter out.
Stopping: The roller shutter can be stopped at any given position by briefly pressing the same
button again.

Direct Operation

• The functions as described in "Using the Remote Control" can be carried out using the two
standard attached buttons.
• Always press the standard buttons for retracting and rolling out the shutter for less than 5
seconds, otherwise the programming mode will be activated!
22