Herunterladen Inhalt Inhalt Diese Seite drucken

Setting The Timer; A) Timer Programming Via The Unit Buttons; B) Timer Programming Via The Remote Control - Conrad FS20 RSU Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

In this way you can use the basic functions of the control switch. If you want to
extend the wireless switching system or use additional special features of the
roller shutter control, please also read the following chapters.

8. Setting the Timer

The timer allows the roller shutter to be fully rolled out or ir through a brief press of the button.
The factory setting is for a period of 1 minute for the roller shutter to be fully retracted or rolled
out. If this period of time is not sufficient or if you desire the roller shutter to be half-rolled out,
this period of time can be freely adjusted to a period between 1 second and 4.25 hours (255
minutes).

a) Timer Programming via the Unit Buttons

• Press the 'roll out' button connected to the "FS20 RSU" for at least 5 seconds.
• As soon as the roller shutter is retracted, the time measurement is started.
• Pressing the button again ends the time measurement and the roller shutter is rolled out
again.

b) Timer Programming via the Remote Control

• Roll out the roller shutter.
• Then press both roller shutter control buttons simultaneously on the remote control for 1 to
5 seconds.
• As s0on as the roller shutter is retracted, the time measurement is started.
• Pressing the roller shutter control buttons simultaneously on the remote control for 1 to 5
seconds again ends the time measurement and the roller shutter is rolled out again.
Please note:
If the time measurement is not manually ended then the programming mode will
be exited after 4.25 hours (255 minutes) and this period will be saved as the timer
period.
23

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis