Check Following Assembly - Korg G1 Bedienungsanleitung

7. Align the bracket holes in the left and right side panels
with the holes in the speaker box, and then secure them
with the four screws (M4) so the gaps on the left and
right sides are equal.
At the same time, secure the cord holder with the top screw
on the left side panel.
Screws (M4)
8. Connect the attached pedal cord, observing the correct
orientation, to the connector on the reverse side of the
pedal unit, and then engage it with a slot in the pedal
unit.
The pedal cord can be attached to or detached from the
connector with its locking tab held down.
9. Lift up either the left or right side of the stand to insert
the pedal unit into the pedal board.
Rear
Push
Front
10. Insert the pedal unit into the pedal board, and then fas-
ten it by pressing a push rivet into the hole (above the
cutout) at the rear of the pedal board.
After installation, lift the stand to check that the pedal unit
does not fall out.
The push rivet will prevent the pedal unit from falling out.
Therefore, it cannot be fully fastened to the pedal board.
11. Firmly tighten the pedal board screws temporarily tight-
ened in step 4.
When tightening the screws on the G1/G1 Air, adjust the
up/down and front/rear positions on the left and right side
panels so that they are equal.
12. Make sure to attach the anti-tipping brackets behind
both side panels. And the anti-tipping bracket fastened
to the left of the code holder at this time.
Attach the anti-tipping brackets, starting with the round
hole at the bottom.
Joints between the side panels and the attached anti-tip-
ping brackets should be even (with no level difference left).
Cord
holder
Screws (M4)
Locking
tab
Rear of pedal board
Push rivet
Reverse
Cord holder
Screws (M4)
13. Ensure that the stand has no gaps and is not tilted, and
that all the screws are tightened firmly.
14. Connect the AC adapter (refer to "Connecting the Pow-
er" on page 5), pedal cord and the speaker cord to the
Connector Panel at the center of the underside of the key-
board unit.
When connecting the pedal cord and the speaker cord, ob-
serve the correct orientations of the connectors.
The pedal cord or the speaker cord can be detached from the
connector with its locking tab held down.
Locking tab
Speaker cord
AC adapter cord
15. Use the two cord holders to secure the AC adapter cord
and pedal cord.
After securing the cord with the cord holder, ensure that
excess pressure is not applied to the connectors.
16. Place the G1/G1 Air where you intend to use it. Make
sure to place it in a safe location where the floor is flat
and stable.
When setting the digital piano in place, make sure
that the stand does not rest on the AC adapter cord or
pedal cord.
For greater safety, be sure to attach the anti-tipping
brackets to the rear of the left and right side panels.

Check following assembly

□ Are any parts left over?
If any parts are left over, carefully review the assembly
procedure to see where those parts should have been used.
□ Make sure that all screws are tight.
Anti-tipping
Bracket
Reverse
Screws (M4) ネジ （Ｍ4）
Pedal cord
Cord
holder
19