Kobra Cyclone Bedienungsanleitung Seite 24

GB
ELECTRICAL INSTALLATION AND WIRING
IMPORTANT!!!
After the Cyclone has been connected to the power supply it may be necessary to check the auto-
shut off time by adjusting the "ALARM C" knob as shown in the "Electrical Set-up and Tuning"
section attached to this operating instruction book.
The adjustment of the "ALARM C" knob allows to adapt the shut-off time of the
Cyclone to the local voltage.
The "ALARM C" knob is already set at the factory but small differences in the local
voltage may require the adjustment of the shut off time after shredding is completed
24 di 55 DI-129/06/30.03.12