Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Warning labels (on top of the housing):
INSTALLATION
Inserting/Replacing the batteries
Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom and remove it.
If replacing the batteries, remove the old batteries from the battery compartment.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty batteries in accordance with the instructions of the manufacturer.
Insert the batteries and make sure that the poles are correct.
Replace the battery cover and close it.
In order to have a long battery life, you should only use alcaline batteries.
Rigging
The installation of the device has to be built and constructed in a way that it can hold 5 times the weight for 1
hour without any harming deformation.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
Procedure:
The device has to be installed out of the reach of people. Always position the laser in a way that laser
projections lie 3 meters above the audience!
If the device shall be lowered from the ceiling or high joists, professional trussing systems have to be used.
The device must never be fixed swinging freely in the room.
Do not stare into the beam or
view directly with optical instruments
CLASS 3A LASER PRODUCT
Danger of explosion when batteries are replaced improperly.
CAUTION EYEDAMAGE!
Always position the laser in a way that laser projections
lie 3 meters above the audience!
LASER RADIATION
Output power: <5 mW
Wavelength: 660-680 nm
EN 60825-1:1999
Caution!
12
Werbung
Inhaltsverzeichnis
