BASETech 2002C Original Bedienungsanleitung Seite 20

• The hot and glowing metal particles that are produced when grinding may cause damage to surfaces
near the sharpener (e.g. table, wall, floor, furniture).
Therefore, do not install and operate the sharpened near high-value surfaces, furniture or floors, or use
suitable supports and protection devices. We recommend using the sharpener, e.g. in an accordingly
suitable hobby room or a garage.
Therefore, also do not use the sharpener near easily flammable objects (e.g. carpet, curtain) or liquids
(gasoline, oil).
• Ensure a secure stance when working with the sharpener. Tripping causes the danger of accidentally
reaching into turning or moving parts; danger of injury!
• Always work in front of the sharpener; do not reach across the sharpener. Body or clothing parts may
enter turning or moving parts; danger of injury!
• Keep the sharpener clean, protect the grips and operating parts without grease and oil. Otherwise, slip-
ping poses danger of injury!
• Operating time must not exceed 20 minutes. Then let the product cool off for at least 20 minutes before
using it again.
• If the product or the mains cable is damaged, do not touch it. Danger to life from electric shock! There
also is a danger of injury from a defective/damaged product.
First deactivate all sides of the mains socket to which the product is connected (e.g. switch off the respec-
tive fuse or turn out the fuse. Then deactivate the FI protection switch).
Do not pull the mains plug from the mains socket by pulling the cable. Do not use the product anymore,
but take it to a specialized workshop or dispose of it in an environmentally compatible manner.
• Servicing or repair must only be carried out by a specialist.
• The following unfavourable conditions are to be avoided at the place of installation and during transport:
- Dust and flammable gases, vapours or solvents.
- strong vibration, impact or blows,
- Strong magnetic fields as present near machines or speakers
• Disconnect the product from the power supply if not used for an extended period (e.g. during storage),
pull the mains plug from the mains socket. Keep the product at a dry, clean site.
• Do not pull the mains plug from the mains socket by pulling the cable.
• When setting up and operating the product, ensure that the mains cable is not bent, crushed or otherwise
damaged.
• Handle the product with care. It can be damaged by impact, blows or when dropped even from a low
height.
• If it can be assumed that safe operation is no longer possible, the device must be turned off and precau-
tions are to be taken to ensure that it is not used unintentionally. Then have the product inspected by a
specialist.
20