Replacing The Fuse; Disposal - TOOLCRAFT ST50-D 50W Bedienungsanleitung

Replacing the Fuse

If the mains switch is not lit when the station is turned on although the outlet is live,
separate the soldering station from the mains by pulling the power plug.
The fuse holder for the circuit breaker is located in the bottom of the station.
You can remove the fuse insert by turning counter-clockwise with a matching
screwdriver.
A defect fuse may only be replaced with a fuse of the same type and with equal
electric parameters. Never repair the fuse!
Ensure a tight fit when screwing in the fuse insert.
If the defect persists after changing the fuse, put the soldering station out of opera-
tion.
Cleaning
The appliance should be cleaned with a clean dry cloth or brush only.
Do not use cleaning agents which contain abrasives, petrol, alcohol or
similar substances for cleaning purposes. Otherwise the appliance
covering could corrode. Moreover the vapours are detrimental to
health and explosive. Nor should sharp-edged tools, screwdrivers,
metal brushes etc. be used for cleaning purposes.

Disposal

When the device has become unusable, dispose of it in accordance
with the current statutory regulations.
28