Initial Operation - TOOLCRAFT ST50-D 50W Bedienungsanleitung

Initial operation

Unpack the soldering station and check all parts for damages. Damaged parts
may not be put into operation.
Place the support for the soldering iron on the side next to the soldering station.
Wet the sponge in the sponge rest with water.
Plug the soldering iron into the 5-pole socket on the soldering station. The plug only
fits in the right polarity.
Place the soldering iron in the support stand. Note that the metal dish of the sup-
port stand heats up over the course of time.
Place the soldering station onto a stable and robust surface.
Connect the mains plug with a live outlet and switch the soldering station on at the
mains switch (I = ON / 0 = OFF).
Set the desired soldering tip temperature at the temperature control (approx.
270 - 360°C for plumbiferous solder).
Alternatively you can also set the temperature via the function keys by pressing
them (PRESET 1-3).The buttons are pre-programmed with the following tempera-
ture values:
PRESET 1
PRESET 2
PRESET 3
To change the preset position, briefly press another button. You leave a preset
position by changing the temperature control.
The bar display (2) shows the heating output of the soldering iron. The number of
bars decreases when the nominal temperature was reached. If the temperature is
exceeded when decreasing, the display goes off until the correct temperature has
been reached again.
Only hold the soldering iron by its handle. Never touch the hot
soldering tip or the shaft. Danger of burning!
Always place the soldering iron into the soldering iron support
while it heats up and when taking breaks during soldering.
Make sure the soldering contacts of the workpiece are clean.
22
= 150°C (standby)
= 270°C
= 360°C