Assignment Of The Function Keys - TOOLCRAFT ST50-D 50W Bedienungsanleitung

Cover the heated soldering tip with solder. Wipe off excess solder on the damp
cleaning sponge.
Heat the soldering spot and add solder.
Let the soldering spot cool off.
Clean the soldering tip on the damp sponge after each soldering work.
After you have finished the soldering work, place the soldering iron into the sup-
port and turn the soldering station off at the operating switch.
Do not file the soldering tip as this destroys it.
Allow the soldering iron to cool down after use.
Never submerge in water.

Assignment of the function keys

The digital soldering stations allows you to save three frequently used temperature
settings on the three function keys. This avoids having to set the temperature via the
control.
The keys were pre-programmed by the factory and can be assigned freely.
For reassigning values, proceed as follows.
Press the desired PRESET key and keep it depressed.
The display shows the following after approx. three
seconds (PS2 = PRESET 2)
Set the desired temperature with the temperature
control.
The top value behind PS1 / PS2 / PS3 shows the nominal temperature for the
respective memory slot.
After letting go of the PRESET button, the new value is saved. Repeat this for the
other buttons.
The saved values are also preserved after turning the station off.
23