Safety - HEYLO KT 20 Betriebsanleitung

13 | Safety

13 Safety
This device has been built using state-of-the-art technology and the following recognized safety and technical
regulations. Nonetheless, danger to the life and limb of the operator or third parties may arise if it is not used
properly. Similarly, the device or other property and material may become damaged.
The device must only be used:
– For the purpose for which it was intended
– And when it is in a perfect technical condition
The device must not be restarted until any fault that may impair safety has been rectified.
Any persons installing, operating, maintaining or cleaning the device must be aware of the hazards that may
arise from electrically operated equipment in environments with a high humidity, and they must have read and
understood this operating manual.
Avoiding hazardous situations
The following instructions apply to anyone working on or with the device:
– The operating manual must be kept at hand, in complete and legible form, at the place where the device is
used.
– The device may only be used for its intended purpose.
– The device must be fully functioning and in a faultless condition. The condition of the device must be
checked regularly before use.
– Accident prevention regulations and any local by-laws must always be adhered to.
Information on electrical equipment
During all work on electrical equipment, the following principles apply:
– The device is operated electrically. There is a risk of fatal injury from faulty installation of the electrical sys-
tem or from a breakdown of the insulation during operation.
– Access to and work on electrical equipment is only allowed for electricians. Always keep switch-boxes
closed.
– The supply from the electrical mains is disconnected when the main switch is switched off.
– After finishing any work, check that protective equipment still functions.
– No unauthorized modifications may be made to the device.
Information on transport and installation
During transport and installation, the following principles apply:
– The device must never be transported to the place of use in an unsecured condition.
– The carrying handle, the transport castors and the trolley handle must always be used to move the device.
48 / 81 EN KT 20