Cleaning And Replacing The Air Filter - HEYLO KT 20 Betriebsanleitung

18 | Cleaning the device and maintaining the filter
Fig. 12:
Pump, removed
1 Connection cable
3 Condensate hose nozzle
5 Condensate hose
a) Switch off the device at the device switch and pull out the mains plug.
b) Open the safety cover at the front of the device.
c) Loosen the pump's two fixing screws and pull them out of the device sideways.
Remove the condensate hose. The connection cable will remain on the device, it is long enough.
d) Clean the pump with a damp cloth and a mild detergent.
e) Slide the pump back into place and secure it with the two fixing screws.
 The pump sump is now cleaned.
18.3

Cleaning and replacing the air filter

The air filter must be checked regularly as the burden on it depends on the conditions in which it is used. If you
use a foam filter, the filter can be cleaned several times. All the other filter mats should be replaced when nec-
essary.
WARNING
68 / 81
Risk of injury from inhaling environmental toxins
Depending on the location, the components of the device may become contaminated
with mould or other environmental toxins.
a) Wear respiratory protection when performing cleaning.
2 Threaded joint
4 Pump
EN KT 20