Operating The External Hygrostat - HEYLO KT 20 Betriebsanleitung

NOTICE
Pumping out the condensate
 The device is not in defrost mode (the yellow indicator light has gone out).
a) Turn the device switch to position [II] and monitor the pumping on the device.
 The condensate pump will start and convey the condensate through the condensate drain hose into the
drain or a collecting vessel.
b) As soon as condensate stops flowing out of the condensate drain hose, turn the device switch immediately
to position [0] to prevent the pump running dry.
 You have now pumped off the condensate and turned off the device.
See also
 Safety [ 48]
16.1

Operating the external hygrostat

 A hygrostat is installed on the nozzle provided at the rear of the device.
 The device is now ready for operation.
a) Set the hygrostat to the desired target humidity.
b) Turn the device switch to position [I].
 The device will begin dehumidifying.
 The device will switch itself off as soon as the set target humidity is reached. The device will remain in a
state of operational readiness. If the target humidity is exceeded, the device will start again.
KT 20
Downtimes
You must drain off the condensate before switching the device off during planned and
longer device downtimes.
Running and operating the device | 16
EN 61 / 81