Wear And Spare Parts - HEYLO KT 20 Betriebsanleitung

CAUTION
 The device is switched off and the mains plug pulled out.
 The device is now defrosted.
Fig. 13:
Dismantling the filter holder
1 Attachment for the filter holder
a) Unscrew the fixing screws of the filter holder.
b) Remove the filter holder at the recessed grip.
c) Take out the contaminated filter.
If there is a foam filter, clean it thoroughly with a mild detergent and water. Let the filter dry.
d) Insert the new or cleaned filter in the filter holder.
e) Mount the the filter holder, including the filter, in the same way as it was installed at the factory.
 You have now maintained the filter.
18.4

Wear and spare parts

Spare parts must meet the technical requirements specified by HEYLO. HEYLO original spare parts have to
fulfill stringent requirements.
EYLO assumes no warranty for any damage caused by the use of spare parts from other manufacturers.
Enquiries and orders In connection with wear and spare parts, please contact your dealer or HEYLO directly
with the following information:
KT 20
Risk of injury on the cooling fins.
The cooling fins have sharp edges.
a) Wear protective gloves.
Cleaning the device and maintaining the filter | 18
2 Recessed grip
EN 69 / 81