Electrolux SG231N Benutzerinformation Seite 49

7.1 What to do if...
Problem
The appliance is noisy.
Audible or visual alarm is
on.
A square symbol is shown
instead of numbers on the
temperature display.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FROSTMAT‐
IC or after changing the
temperature.
Water flows on the floor.
Possible cause
The appliance is not sup‐
ported properly.
The cabinet has been re‐
cently switched on or the
temperature is still too
high.
The temperature in the
appliance is too high.
Temperature sensor prob‐
lem.
The lamp is in stand-by
mode.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FROSTMATIC func‐
tion is switched on.
This is normal, no error
has occurred.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
ENGLISH
Solution
Check if the appliance
stands stable.
Refer to "Door Open Alarm/
Indicator" or "High Tempera‐
ture Alarm/Indicator".
Refer to "Door Open Alarm/
Indicator" or "High Tempera‐
ture Alarm/Indicator".
Contact the nearest Author‐
ised Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).
Close and open the door.
Contact the nearest Author‐
ised Service Centre.
Refer to "Operation"/"Control
Panel" chapter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "FROSTMATIC
function".
The compressor starts after
some time.
Attach the melting water out‐
let to the evaporative tray.
49