Product Identification - Meradiso Z30155 Bedienungsanleitung

Fixing the beds side by side:
j
P lace the two air beds
so that the ends with the pillows
same direction (see Fig. C).
j
C lose the buckles
4
Maintenance
Q
Mending airbed and pillow
Q
note: Minor damage may be repaired using the
supplied repair kit. Have any major damage carried
out at a specialist repair shop.
note: Suitable adhesive can be obtained at
specialist dealers.
m CAUTIOn! rISK OF InJUrY! Keep the
glue out of the reach of children. Avoid contact with
skin. Protect your eyes. Use protective goggles if
necessary. Do not inhale or eat the glue.
j
F irst let the air out of the product (see "Deflating
airbed and pillow").
j
C lean the damaged area with alcohol.
j
A brade the area around the site of the damage
with fine sandpaper.
j
C ut out a piece of the plastic film in the repair kit.
note: Make sure that the patch largely over-
laps the edges of the leak.
j
R ound the corners off and place the patch over
the leak or hole. Use a pencil to draw around
the edges of the patch.
j
A pply the suitable glue (not included in delivery)
onto the underside of the patch and around
the leak or hole.
j
A pply glue all over the leaky area.
IMPOrTAnT! You must follow the directions
for use that come with the glue. They contain
important information regarding its handling
and drying time.
j
P ress the patch firmly down onto the leak. You
may have to place a heavy object onto the
relevant area.
j
A llow the adhesive to dry for approximately
3 minutes.
j
T hen spread adhesive to the edge of the repair
and let it completely dry.
Operation / Maintenance / Cleaning and care / Disposal
next to each other
9
point in the
10
as described above.
j
W ait for 24 hours before you pump up the
product again.
Cleaning and care
Q
j
C lean the flocked surface of the product using
a brush.
j
C lean the plastic surfaces with water and / or a
little mild soap solution.
j
D o not use corrosive or abrasive cleaning agents.
j
D o not expose the product to extreme weather
conditions such as extreme temperature, wind
and rain.
j
D o not allow the product to be subjected to frost.
j
E nsure that the inside and outside of the product
are completely dry if you intend to store it
indoors for a long period. Failure to observe
this advice could result in the build-up of mildew
and mould.
j
F old up the product with the flocked surface on
the inside.
j
S tore the product in dark, dry place – out of
reach of children.
j
T he ideal storage temperature is between
10 and 20 °C.
j
M ake sure that the valve
wish to store the product for any length of time.
j
D o not allow sharp objects to come into con-
tact with the product while it is in storage.
j
N ever powder the product with talcum.
Disposal
Q
The packaging is made entirely of
recyclable materials, which you may
dispose of at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.

Product identification:

Comfort double air bed
Model no.: Z30155
Version: 07 / 2010
, is shut if you
3 8
GB/IE 7