Installation And Connection - Oase ProMax Rain 4000 Gebrauchsanleitung

• Do not use for long-term operation (e.g.
continuous recirculation of the water in
a pond).
• Do not use for commercial or industrial
purposes.
• Do not use in conjunction with chemi-
cals, foodstuff, easily flammable or ex-
plosive substances.
• Do not connect to the drinking water
supply.

INSTALLATION AND CONNECTION

Connecting the pressure hose
An optimum flow rate is achieved with the
largest possible hose inside diameter.
How to proceed:
 B
1. Screw the quick-release coupling onto
the pump outlet.
2. Fit the hose connector onto the quick-
release coupling.
Fitting the connection set
The connection set makes it possible to
route the pressure hose (G½) via the kink
protection.
 C
Fitting the kink protection
Using the kink protection, the pressure
hose (G½) can be routed over an edge
without any kinks.
How to proceed:
 D
1. Place the pressure hose into the kink
protection.
2. Fold down the cover clips and allow the
fasteners to engage.
3. Hang the pressure hose over the edge.
14
Removing the kink protection
 D
• Press both fasteners and push them out
of the lugs.
• Undo the cover clips and remove the
pressure hose.
Automatic mode
When the water level rises, it lifts the float
switch until the switch-on point is reached
and the pump switches on.
When the water level drops, the float
switch lowers until the switch-off point is
reached and the pump switches off.
 E
• Push the float switch cable into the ca-
ble clip.
– The shorter the cable between the
float switch and the cable clip, the
lower the switch-on point and the
higher the switch-off point.
N O T E
To ensure faultless function, ensure that
the length of cable between the float
switch and the cable clip measures at
least 10 cm.
N O T E
The minimum residual water height is
only reached in manual mode.
ProMax Rain 4000