Installation Variants; Installation And Connection - Oase AquaMax Eco Twin 20000 Inbetriebnahme

1 Inlet 1 (suction side)
• Connection of a satellite filter or skimmer.
• Water flow through pump 1.
2 Inlet 2 (suction side)
• Filter housing
• Water flow through ...
− pump 1 or 2 or
− pump 1 and 2.
3 Outlet (pressure side)
• Connection of the return line into the pond (e.g. via a water course).
4 Receiver for controlling the pumps via the hand-held transmitter.
5 Ground stake for installing the receiver.
6 Hand-held transmitter for controlling the pumps. (→ Operating functions)
7 Hose sleeve for outlet (recommendation).
8 Stepped hose adapter for inlet 1 and outlet (alternative).
9 Adapter for inlet 1.
10 Hose clips for fastening hoses on the hose sleeves.

Installation variants

 A
• Variant (a): Water flow only through the filter housing.
– Pump 1 and 2 either operate in parallel or separately.
• Variant (b): Water flow through the filter housing and through an additional satellite filter or
skimmer.
– Water flows through a satellite filter or a skimmer on inlet 1 to pump 1.
– Water flows through the filter housing (inlet 2) to pump 2.

Installation and connection

The use of the pump is only permitted with observance of the specified water quality.
• Pool water or salt water can impair the appearance of the unit. Such impairments are excluded
from the guarantee.
WARNING
Severe injuries or death due to operation of this unit in a swimming pond. Defective electrical
components will electrify the water with dangerous electrical voltage.
Never operate the unit in a swimming pond.

EN
15