Scope Of Delivery/Part Names (Figure A); Technical Data; Correct Use; Symbols Used - Crivit AT-2154 Gebrauchsanweisung

Congratulations!
With your purchase you have decided on a
high-quality product. Get to know the product
before you start to use it. Carefully read the
following instructions for use.
Use the product only as described and only for
the given areas of application. Keep these instruc-
tions safe. When passing the product on to a third
party, always make sure that the documentation
is included.
Scope of delivery/
Part names (figure A)
1 x Arm and leg trainer with resistance screw
and display (incl. AAA battery LR03) (1)
1 x Foot, small (2)
1 x Foot, large (3)
2 x Pedals (4)
4 x Screws (5)
4 x Washers (6)
1 x Allen key with screwdriver (7)
1 x Wrench (8)
1 x Instructions for use

Technical data

Dimensions: approx. 42 x 31 x 38cm
(W x H x D)
Weight: approx. 4.8kg
Maximum load capacity: 100kg
Device class: HC (for use in private households,
exactitude C)/not suitable for therapeutic training;
Non-speed dependent exerciser.
WARNING! This stationary exerciser is not
suitable for high accuracy purposes.
Rotational speed-independent exerciser
The resistance can be set independent of the
speed.
Energy supply: 1.5V

Correct use

The article is not designed for commercial use.
The article allows the user to train arms and legs;
fitted with a resistance screw to increase and
maintain mobility. An integrated display shows the
training progress.
8 GB/IE/NI
battery type AAA, LR03

Symbols used

Date of manufacture (month/year):
06/2018

Safety notes

Important: Read the instruc-
tions for use through care-
fully and always keep them
for future reference!
• The article is not suitable for
therapeutic purposes.
• Sit in a relaxed, upright positi-
on with a straight back during
the exercises.
• Exchange any defective parts
of the article immediately and
discontinue use until the main-
tenance is carried out.
• Please note that incorrect or
excessive training can cause
injury to health.
• Stand the article on a horizon-
tal, level surface.
• Use a non-slip mat on a smooth
surface.
• Pay attention to wear to the
parts. If the article no longer
exhibits any resistance on the
pedals then the drive belt is
worn and the article needs to
be replaced.
• An area of approx. 0.6m must
be present around the training
area (figures I and J).