Rc Functions Of The Helicopter; Technical Data - Carson EasyTyrann 180 Betriebsanleitung

b. RC Functions of the Helicopter
The following functions are controlled with
the two remote control levers of the porta-
ble transmitter.
For every control function there is a trim slider on the remote
control transmitter which permits minor corrections of the
neutral position.
Pitch function
(Ascend/descend)
The pitch function controls the flying height of this model
helicopter over a common variation in speed of the two rotors.
The control takes place with the left control lever.
To do this, move it forwards and backwards
in a continuously variable fashion.
Contrary to the other control functions this lever does not
spring back into the middle position. If the control lever is
totally drawn towards the back, then the
motors are off and the rotors stand still.
If the control lever is pushed forward then
the motor starts running and the rotors run
with increasing speed depending on the lever
position.
In the middle position of the control lever, the
helicopter should hover at a fixed height.
Tail rotor function
(Rudder function)
The tail rotor function causes a rotation of the
model around the vertical axis. Since the helicopter has two opposed
rotors, no torque ensues around the vertical axis at the same speed
of the rotors (rotor shaft). The helicopter also therefore requires no
tail rotor for stabilization. In order for the model to be able to rotate
around the vertical axis (rotor shaft), the rotors must run at slightly
different speeds. The resulting torque introduces the rotation.
At less speed of the steering rotor compared to the bearing rotor, the
torque of the bearing rotor is greater, the helicopter turns around the
vertical axis in the direction of rotation of the steering rotor. At higher
speed of the steering rotor, the torque of the bearing rotor is less than
that of the steering rotor and the helicopter turns in the direction of
the bearing rotor.
The tail rotor function is controlled with the right control lever. If the
lever is moved to the left, the tip of the fuselage turns to the left. If you
move the lever to the right, the tip of the fuselage likewise turns to the
right.
c. Technical Data
Principal rotor diameter 195 mm
Length 185 mm
Height 113 mm
Weight 40 g
Battery charger "LiPo" inside the transmitter or via USB
Input 230 V/ AC, 50/ 60 mA
Output 350 mA
Roll function
(Aileron function)
The roll function causes the lateral flight of the helicopter.
The control takes place with the right control lever.
If the lever is moved to the left, then the model hovers laterally to the
left. Moving the lever to the right makes the model move laterally to
the right.
Nick function
(Elevator function)
The nick function causes forwards and backwards flight of the
helicopter. The lower rotor rotation tips slightly downwards and
the model tilts around the transverse axis. When the nose drops
downwards, a part of the lift is transferred into forwards thrust.
If conversely the nose is raised, then the model flies backward. the
control takes place with the right control lever.
Press the lever forward to introduce forwards flight, pull back to have
the model fly backwards.
CARSON Easy Tyrann 180 • 50 050 7048
GB G
23