Assembly; Operation - McCulloch B43BT Bedienungsanweisung

center. Do not use the product until the product is
correctly adjusted or repaired.
WARNING: Read the safety chapter before
you assemble the product.
To install the handlebar
1. Attach the handlebar onto the mounting bracket as
shown. (Fig. 32 )
2. Attach the cable to the shaft with the zip ties.
To install the protective guard
• Attach the protective guard onto the shaft as shown.
(Fig. 33 )
To attach the cutting attachment guard
for the trimmer head and grass blade
• Attach the cutting attachment guard onto the shaft as
shown. (Fig. 34 )
To attach the cutting attachment guard
for the saw blade
• Attach the cutting attachment guard onto the shaft as
shown. (Fig. 35 )
To install the trimmer head
1. Attach the drive disc on the output shaft.
2. Turn the output shaft until one of the holes in the
drive disc aligns with the related hole in the gear
housing.
3. Put the hex wrench in the hole to lock the shaft.
4. Turn the trimmer head onto the shaft. (Fig. 36 )
To install the grass blade
1. Attach the drive disc on the output shaft.
2. Turn the output shaft until one of the holes in the
drive disc aligns with the related hole in the gear
housing.
3. Put the hex wrench in the hole to lock the shaft.
4. Install the blade on the shaft.
5. Attach the support flange, washer and nut on the
output shaft.
6. Tighten the nut fully with the socket wrench.
WARNING: Read and understand the safety
chapter before you operate the product.
16

ASSEMBLY

7. Install the retainer pin in the nut. (Fig. 37 )
To install the saw blade
1. Attach the drive disc on the output shaft.
2. Turn the output shaft until one of the holes in the
drive disc aligns with the related hole in the gear
housing.
3. Put the hex wrench in the hole to lock the shaft.
4. Install the blade on the shaft. Make sure the cutters
point in the correct direction.
5. Attach the support flange, washer and nut on the
output shaft.
6. Tighten the nut fully with the socket wrench.
7. Install the retainer pin in the nut. (Fig. 38 )
To adjust the harness
(Fig. 39 )
1. Put on the harness.
2. Adjust the harness for the best work position.
3. Adjust the side straps until the weight is equally
distributed across your shoulders.(Fig. 40 )
4. Adjust the harness until the cutting attachment is
parallel to the ground.
5. Let the cutting attachment stay lightly on the ground.
And then adjust the harness clamp to balance the
product correctly.
Note: If you use a grass blade, it must balance
approximately 10 cm (4 in) above the ground to keep
the grass blade from stones and so on.
To attach the transport guard
1. Attach the transport guard on the blade as shown in
the illustration.(Fig. 41 )

OPERATION

WARNING: The product must always be
hooked securely to the harness. Never use
a harness with a defective quick release.
WARNING: Use the harness release
function if you must release from the product
and the harness in an emergency situation.
462 - 002 - 07.02.2018