Technical Data - Riello Burners 565M Montage- Und Bedienungsanleitung

TECHNICAL DATA

TYPE
Thermal power
Pci
Natural gas
(Family 2)
Pressure
Electrical supply
Motor
Capacitor
Ignition transformer
Absorbed electrical power
For gas family 3 (LPG) ask for separate kit.
COUNTRY
GAS CATEGORY
The burner meets protection level of IP X0D (IP 40) as EN 60529.
The burner is approved for intermittent operation as per Directive EN 676.
CE marking according to Gas Appliance Directive 90/396/EEC; PIN 0063AP6680.
Burner with CE marking in conformity with EEC Directives: EMC 89/336/EEC, Low Voltage
73/23/EEC, Machines 98/37/EEC and Efficiency 92/42/EEC.
Gas train according to EN 676.
1 – Air damper
2 – Damper fixing screws
3 – Grommet
4 – Hood fixing screw
5 – Pressure switch
6 – Motor
7 – Lockout lamp with reset button
8 – Control box
9 – 6 pole socket for gas train
10 – Capacitor
NOTES
– The grommet (3) supplied with the burner, must be fitted to the same side of the gas train.
– After having installed the burner verify the access to the fixing screws of the cover.
If necessary, replace them with the fixing screws (4, fig.1) supplied as accessories.
3313
565M
11 − 35kW
8 − 12 kWh/m
min. 10 mbar – max. 40 mbar
Single phase, 230 V ± 10% ~ 50Hz
Run current 0.75 A
2 μF
primary 230 V / 0.2 A
0.15 kW
IT - AT - GR - DK - SE
II2H3B/P
8
9
4
3
9,500 − 30,000 kcal/h
–
– 7.000 − 10.340 kcal/m
3
- 2800 rpm - 294 rad/s
–
GB - IE FR
II2H3P II2Er3P
5
GB
1
ENGLISH
3
secondary 8 kV
DE
II2ELL3B/P II2E3B/P
6 10
LU
Fig. 1
7
1
2
2
D7386