Select Button - Sony TSL-9000 Bedienungsanleitung

1 Indicates a cleaning request. (Drive needs cleaning.)
2 End of tape reached during cleaning.
3 DDS cartridge loaded with incorrect orientation or slide
shutter is positioned incorrectly. Remove all cartridges
from the magazine, then reload them correctly.
4 Magazine does not contain correct number of cartridges.
"1" is displayed when:
the drive automatically requests head cleaning after every 24 hours of
drum rotation, or the drive is unable to read or write data due to debris
on the read/write head.
If "1" appears frequently, the cartridge should be replaced.
e
Cartridge number indicator
The eight numbered boxes on the bottom of the LCD screen show which
slots in the magazine contain cartridges. A blinking number indicates that
a cartridge is being loaded. A number does not appear if a cartridge is not
present in the magazine, and turns on when the cartridge is returned to
the magazine.
4

SELECT Button

Push to select the number of a data cartridges set into the magazine. The
selected cartridge is loaded into the DDS drive.
5
TAPE Indicator
Lights green when a data cartridge is loaded into the SDT-9000. The
indicator flashes while a cartridge is being loaded or unloaded.
6
BUSY Indicator
Lights green when the SCSI interface is ready for data transfer. This
indicator flashes under the following conditions:
While data is being read from the
cartridge loaded into the DDS drive,
while searching for data, or while the
cartridge is being rewound:
While data is being written to the
cartridge loaded into the DDS drive:
When WARNING indicator lit
Green lamp flashes with equal-
length on and off intervals.
Yellow lamp flashes with equal-
length on and off intervals.
Chapter 1 Introduction
9