Inhaltsverzeichnis
Werbung
Prescribed use
The device is intended for non-contact measuring of temperatures of -50°C to
+1000°C. As power supply, use a 9V block battery of the type 006P, IEC6F22,
NEDA 1604 or similar types only. Operate the device in dry environment only.
Do not expose it to moisture.
Any use other than one described above damages the
product. Moreover, this involves dangers such as e.g. short
circuit, fire, etc. No part of the product must be modified or
rebuilt and the housing must not be opened!
Scope of Delivery
• Infrared Thermometer IR-1000L
• Storing case
• 9V block battery
• Operating manual
Safety instructions
In the case of any damages which are caused due to the
failure to observe these operating instructions, the
guarantee will expire! We do not assume liability for
resulting damages!
Nor do we assume liability for damage to property or
personal injury caused by improper use or the failure to
observe the safety instructions. The guarantee will expire in
any such case.
An exclamation mark in a triangle stands for important
instructions in the operating manual. Carefully read the
whole operating manual before putting the device into
operation.
The unauthorized conversion and/or modification of the unit is inadmissible
because of safety and approval reasons (CE).
Always observe the safety instructions, warnings and the chapter "Prescribed
use" in order to ensure safe operation.
Please observe the following notes before using the device:
12
Maintenance and care
Blow loose dirt particles off the IR lens (1). Remove residual dirt particles by
means of a fine lens brush. Clean the exterior of the device with a slightly
moistened cloth. Moisten the cloth with water only. Do not use chemicals or
cleansing agents for cleaning.
Disposal
Please dispose of the unserviceable device according to the relevant statutory
regulations.
Technical data
Display
: 2000-count display with background lighting
sensor
: thermopile
Measuring lens (D/S)
: 12:1
Temperature measuring
: -50 to + 1000 °C
range
Response time
: < 1 second
Overflow indication
: „1" at temperatures of > 1000 °C or < -50 °C
Emission ratio
: 0.95 preset
Target indication
: laser, 630-670 nm, < 1 mW, class 2
Automatic cut-off
: after approx. 10 seconds
Operating temperature
: 0 to +50 °C
Storing temperature
: -20 to +60 °C
Relative air humidity
: 10 to 90 % RH
Power supply
: 9 V block battery
Weight
: 290 g
Dimensions
: 100 x 56 x 230 mm
Accuracy and resolution
Range
-50 to -20 °C
-50 to +200 °C
-20 to +200 °C
+201 to +538 °C
+539 to + 1000 °C
Resolution
Accuracy
0.1 °C
± 5 °C
± 1.5 % of the measuring
value ± 2 °C
1 °C
± 2.0 % of the measuring
value ± 2 °C
± 3.0 % of the measuring
value ± 5°C
17
Werbung
Inhaltsverzeichnis
