Count-Up Function; Cleaning - Silvercrest SPLD 2 A1 Bedienungsanleitung

Count-up function

♦ If the timer 3 is in standby mode, press any button
to switch it on .
♦ If the display 5 shows the last set time, simulta-
neously press the buttons "Min" 7 and "Sec" 4
(=reset) to reset the time .
♦ To start the count-up, press the "Start/Stop" button 6 .
NOTE
► You can stop the count-up at any time by press-
ing any button . To resume the count-up, press
the "Start/Stop" button 6 .

Cleaning

CAUTION! PROPERTY DAMAGE
► Do not use abrasive, chemical or caustic cleaning
agents to clean this product . These could damage
the surface of the product .
► Never immerse the timer 3 in water or other
liquids .
♦ If you have not already done so, detach the tim-
er 3 from the Pasta Server and clean it with a
damp cloth . If necessary, put a little mild detergent
on the cloth and wipe the product off afterwards
with a cloth dampened with clean water only .
♦ Clean the Pasta Server 1 in warm water using a
mild detergent . Allow the product to dry thoroughly
before reattaching the timer 3 .
NOTE
You can also clean the Pasta Server 1 in
the dishwasher . Make sure to remove the
timer 3 first .
SPLD 2 A1
GB │ MT │ 23 ■