Installation Instructions - Nabo KI 1235 Bedienungsanleitung

Installation instructions

! It is recommended that this installation be performed by authorized technical stuff.
! Before installation, read the instructions carefully.
! Fit the refrigerator / freezer in stable kitchen units only.
! Cabinet dimensions are changed by material of trim flap
1. If material of trim flap
2. If material of trim flap
! If necessary, reverse the door according to instructions.
1. See fig.A for the necessary attachment components.
2. Open the package. Take gasket spacer
middle part is door hang rail
3. Insert trim flap
4. Pass the power cord through ventilation shaft and position it so that the appliance could
be easily plugged in once it has been installed. (fig.B - fig.C)
5. Cut trim gasket
hinges of the appliance. (fig.E)
6. Raise the appliance and slide into the kitchen unit.
7. Lean the appliance to the kitchen unit through the hinges and align the front feet with front
surface of the kitchen unit. (fig.F)
8. Open the appliance door and screw the front feet by using screws
9. Screw trim flap
10. Screw the hinges to the kitchen unit using screws
11. Close the appliance door. Unscrew and remove the nuts
bolts from the appliance door. (fig.H)
(12)
12. Take out the liners of the tapes on door hang rails
appliance door by inserting the bosses on the holes of the appliance door, aligning the
front surfaces of the door hang rails
the door hang rails
13. Slide the door hang
14. Take out the liners of the tapes on the front side of the door hang
15. Take out the liners of the tapes on the unit door spacers
unit door , closer to the upper corners. (fig.K)
(15)
16. Lean the unit door
right and top edges with the sides of the unit or the doors of the nearer and upper kitchen
units. (fig.K)
17. Make sure that the unit door
the door hang
(2)
stuck on the unit door
18. Lay down the unit door
by screws . (fig.L)
(7)
19. To overcome some of the furniture mistakes, there are plastic spacers
door hang . Remove these plastic spacers
(2)
is plastic, look at (Table.1/B1) for cabinet dimensions.
(1)
is metal, look at (Table.1/B2) for cabinet dimensions.
(1)
. The other two parts are unit door spacers
(10)
into slot and screw by screws
(1)
to the height of the recess and stick it on reverse side of the door
(4)
to kitchen unit using screws
(1)
, stick onto the appliance door. (fig.H)
(10)
into door hang rails
(2)
to the door hang
(15)
sticks onto the door hang
(15)
to slide out the door hang rails
. (fig.L)
(15)
on the floor and screw the door hang
(15)
(1)
and brake into three as shown in figureD. The
(9)
. (fig.E)
(8)
. (fig.G)
(7)
. (fig.G)
(7)
. Place door hang rails
(10)
and the appliance door parallel to each other. Let
(10)
. (fig.J – fig.K)
(10)
, aligning the unit door spacers
(2)
. Observe that the door hang
(10)
. (fig.M)
(A)
EN - 40 -
.
. (fig.G)
(7)
, washers and adjustment
(14) (13)
.
(2)
and and stick them onto the
(11)
. Pull the unit door
(2)
to the unit door
(2)
sticked on the
(A)
. (fig.D)
(11)
on the
(10)
on the left,
(11)
allowing
(15)
stays
(2)
(15)