Temperature Control; 3 Placement; 4 Installation Of Door Handle - Nabo KR 1000 Gebrauchsanleitung

2.2 Temperature Control

( The picture above is only for reference. The actual configuration will depend on the physical
product or statement by the distributor )
The figures do not mean specific set temperature, but temperature level.
"COLD" means the warmest setting
"COLDER" means the coldest setting
The higher the figure is, the lower the actual temperature inside refrigerator shall be.
"OFF" means stop running.

2.3 Placement

2.4 Installation of door handle

Users can install it by themselves
S First install the handle base
screws until the door handle does not shake.
S Align the handle cover
install the handle cover in place by hand.
S
2
( The picture above is only for reference. The actual configuration will depend on the physical
product or statement by the distributor )
Before using the refrigerator,
remove all packaging
materials including bottom
cushions and foam pads
and tapes inside the
refrigerator , tear off the
protective film on the door
and the refrigerator body.
Keep away from heat and
avoid direct sunlight. Do not
place the refrigerator in
moist or watery places to
prevent rust or reduction of
insulating effect.
1
into the reserved hole
3
with the hole on the handle base
1
EN-7
The refrigerator should be
placed in a well-ventilated indoor
place; the ground shall be flat,
and sturdy.
The top space of the refrigerator
shall be greater than 30cm,and
the distances from bothsides
and backside shall be more
than 10cm to facilitate heat
dissipation.
2
on the door, and tighten the
1
, push forward, and
1
3