Installing And Operating Your Fridge - Nabo KI 1235 Bedienungsanleitung

• Do not touch frozen goods with wet hands! Do not eat ice-cream and ice cubes
immediately after you have taken them out of the freezer department!
• Do not cover the body or top of fridge with lace. This affects the performance of your
fridge.
• Secure any accessories in the fridge during transportation to prevent
damage to the accessories.

Installing and operating your fridge

Before starting to use your fridge, you should pay attention to the following points:
• The operating voltage for your fridge is 220-240 V at 50Hz.
• The plug must be accessible after installation.
• Your fridge may have a smell when it is operated for the first time. This is normal and
the smell will fade away when your fridge starts to cool.
• Before connecting your Fridge Freezer, ensure that the information on
the data plate (voltage and connected load) matches that of the mains
electricity supply. If in doubt, consult a qualified electrician.
• Insert the plug into a socket with an efficient ground connection. If the
socket has no ground contact or the plug does not match, we
recommend that you consult a qualified electrician for assistance.
• The appliance must be connected with a properly installed fused
socket. Power supply (AC) and voltage at the operating point must match with the
details on the name plate of the appliance (name plate is located on the inside left of
the appliance).
• W e do not accept responsibility for any damages that occur due to ungrounded
usage.
• Place your fridge where it will not be exposed to direct sunlight.
• Your fridge should never be used outdoors or exposed to rain.
• Your appliance should be at least 50 cm away from stoves, gas ovens and heater
cores, and at least 5 cm away from electrical ovens.
• W hen your fridge is placed next to a deep freezer, there should be at least 2 cm
between them to prevent humidity forming on the outer surface.
• Do not place heavy items on the appliance.
• Clean the appliance thoroughly, especially the interior, before use (see Cleaning and
Maintenance).
• The installation procedure into the kitchen unit is given in the Installation Manual.
This product is intended to be used in proper kitchen units only.
• Use the adjustable front legs to make sure your appliance is level and stable. You
can adjust the legs by turning them in either direction. This should be done before
placing food in the fridge.
• Before using your fridge, wipe all parts with a solution of warm water and a teaspoon
of sodium
Place all parts in the fridge after cleaning.
bicarbonate, then rinse with
EN - 29 -
clean water and dry.