Installation And Operating Conditions Of The Appliance; Preparing For Operation - Nabo KT 3100 Gebrauchsanweisung

INSTALLATION AND OPERATING CONDITIONS OF THE
Position:
This appliance can be installed in a dry, well ventilated indoor where the ambient
•
temperature corresponds to the climate class indicated on the rating plate of the
appliance.
WARNING! The appliance should not be operated in an unheated room or
porch. Place the appliance away from heat sources such as kitchen
stove/oven, radiators, or direct sunlight.
The rear wall of the refrigerator, in particular, the condenser and other
elements of the cooling system must not contact other elements, which may
damage them, (e.g. central heating pipes and the water supply pipes).
Minimum distances from the heat sources:
- from the electric gas and other ovens - 30 mm,
- from oil or coal fired ovens - 300 mm,
- from built-in ovens - 50 mm
If there is no possibility of ensuring the above- mentioned distances, provide an
appropriate insulation board.
Do not cover the ventilation holes at the top of the appliances– it must be a good air
•
circulation around the appliance. There should be a gap of at least 10 cm between the
top of the appliance body and any furniture that may be above it. If this requirement is
not followed, the appliance consumes more electrical energy and its compressor may
overheat (see fig. 4, page 2).
If the appliance is placed in a corner, a gap of at least 60 mm must be left between the
•
appliance body and the wall (see fig. 5, page 2).
The appliance must stand on a level surface and must not touch the wall. If necessary,
•
regulate the height of the appliance by adjusting the levelling feet: by turning them
clockwise – the front of the appliance rises, by turning them counter clockwise – it
comes down. If the appliance is tilted slightly backward – the doors will close by
themselves.

Preparing for operation:

It is recommended to prepare the appliance for operation with a helper.
•
Remove package. Remove the separate polystyrene part (transport protection) between
•
the rear of the device and condenser – metal grid (if available). Lift the appliance away
from foamed polystyrene base. When placing, moving, lifting the appliance, do
not hold the door handles, do not pull the condenser at the rear part of the
refrigerator and do not touch the compressor unit.
When positioning the appliance in chosen location, it will move more easily into position
•
if you lift the front a little and incline it backward, allowing it to roll on its casters.
Remove all red-coloured parts from the shelves (see fig. 2, page 1). Tear away the
•
adhesive tapes
Take two supports 1 from the bag (see fig. 3, page 1) and insert them into the guides 2
•
at the top back part of the appliance.
APPLIANCE
15