Before Using Your Fridge; How To Operate The Appliance; Thermostat Setting - Nabo KI 1235 Bedienungsanleitung

• Install the plastic distance guide (the part with black vanes at the
rear) by turning it 90° (as shown in the figure) to prevent the
condenser from touching the wall.
• The refrigerator should be placed against a wall with a free
space not exceeding 75 mm.

Before Using your Fridge

• W hen using your fridge for the first time, or after transportation, keep it in an upright
position for at least 3 hours before plugging into the mains. This allows efficient
operation and prevents damage to the compressor.
• Your fridge may have a smell when it is operated for the first time. This is normal and
the smell will fade away when your fridge starts to cool.
PART 2.

HOW TO OPERATE THE APPLIANCE

Thermostat Setting

• « • » position shows thermostat is closed and no cooling will take place.
• For short-term storage of food in the freezer compartment, you can set the knob
between minimum and medium positions (1-3).
• For long-term storage of food in the freezer compartment, you can set knob to the
medium position (3-4).
Note that: The ambient temperature, temperature of the freshly stored food and how
often the door is opened, affects the temperature in the refrigerator compartment. If
required, change the temperature setting.
• When you first switch on the appliance, leave the appliance running continuously for
24 hours in order to reach operating temperature.
• During this time, try to limit the number of times that the door is opened and do not
store a large quantity of food in the appliance.
• If the unit is switched off or unplugged, you must allow at least 5 minutes before
restarting or plugging the unit in. This avoids damage to the compressor.
• The freezer of the refrigerator can cool up to -18°C .
• This appliance is designed for use at an ambient temperature within the 16°C - 32°C
range.
• The thermostat automatically
regulates the inside temperature of
the refrigerator compartment and
freezer compartment. By rotating the
knob from position 1. to 5., colder
temperatures can be obtained.
EN - 30 -