Installation And Connection - Oase BioCompact 50 Gebrauchsanleitung Und Garantie

- EN -
4. Push the suction cups into the mounting holes of
the filter container and motor housing with a twist-
ing movement.
5. Reassemble the unit in the reverse order.
6. Adjust the flow at the flow regulator.
– To reduce the flow: Move the flow regulator in
the direction Min.
– To increase the flow: Move the flow regulator
in the direction Max.
7. Fit the water distributor.
BioCompact 50
How to proceed:
 B
1. Remove the lid of the filter container.
2. Pull out the foam holder.
3. Pull out the filter box.
4. Fill the empty chamber of the filter box with filter
medium.
5. Push the suction cups into the mounting holes of
the filter container with a twisting movement.
6. Reassemble the unit in the reverse order.
7. Adjust the flow at the flow regulator.
– To reduce the flow: Move the flow regulator in
the direction Min.
– To increase the flow: Move the flow regulator
in the direction Max.
8. Fit the water distributor.
16

INSTALLATION AND CONNECTION

N O T E
Ensure that the pump never runs dry!
Possible consequences: The pump will be destroyed.
Protective measure: Regularly check the water level
in the aquarium.
 C
• Fasten the device, e.g. to the wall of the aquarium.
• Route the power connection cable such that it
forms a drip loop!
• Switching on: Connect the unit to the mains. The
unit switches on immediately.
• Switching off: Disconnect the unit from the mains.
BioCompact 25/50