Led Light; Interior Equipment - hanseatic SC-70W Gebrauchsanleitung

Page GB-12 Operation
Decreasing the temperature:
– Push the button to decrease the tem-
perature (15) until the desired tempera-
ture appears.
Increasing the temperature:
– Push the button to increase the (9)
temperature until the desired tempera-
ture appears.
If you hold down the
the temperature indicator will auto-
matically scroll through the temperature
settings.
3. To confirm the temperature selection,
– press the SET button once.
The temperature indicator changes back
to display the current interior tempera-
ture.
– wait approx. 8 seconds. If no further in-
put is made during this time, the flashing
will stop and the setting will be saved.
The current interior temperature will be
shown. The desired temperature has been
set.

LED light

Switching on
• Push the light switch (12)
appliance will beep and the LED light will
turn on.
Switching off
• Push the light switch (12)
appliance will beep and the LED light will
turn off.

Interior equipment

The bottle shelves (7) can be removed and
rearranged if necessary.
Removing the shelves
• Lift the rear of the bottle shelf slightly and
pull it out.
or button,
shelf (6) can also be removed from the appli-
ance by pulling them out.
Inserting the shelves
1. Turn the bottle shelf (7) so that the front
and back rails (17) and (16) are facing up.
2. Insert the bottle shelf into the side brack-
ets, so that the front rail is facing forward.
3. Slide the bottle shelf towards the back of
the appliance until it locks into place.
once. The
once. The
The presentation box (5), presentation
shelf (8) as well as the small bottle
(16)
(17)