Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
Requirements for safe use
– You have read chapter „Safety" from page
GB-6 and understand all the safety notices.
– The appliance is set up and connected as
described in chapter „Start-up" from page
GB-17.
Switching the appliance on
and off
NOTICE
Risk of damage!
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
pressor may get into the cooling circuit.
Allow the appliance to stand upright
■
for approx. 2 hours after transport
and before connecting.
Switching on
• Insert the mains plug into an easily acces-
sible socket (220–240 V~ / 50 Hz).
The temperature indicator (14) will light
up. The appliance is switched on.
Switching off
1. Disconnect the mains plug from the socket.
The temperature indicator (14) will shut
off.
The compressor is switched off. The ap-
pliance doesn't refrigerate.
2. Empty the appliance and clean it (see
„Care and maintenance" on page GB-15).
3. Leave the glass door (3) slightly ajar to
prevent mould from forming.
Operation
Controlling the temperature
The current interior temperature can be read
from the temperature indicator (14) while in
operation.
If you want to control your temperature set-
ting,
• press the SET function button (13) once.
The appliance will beep and the temper-
ature indicator (14) will flash the set tem-
perature.
Setting the temperature
WARNING
Health hazard!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
Always abide by the prescribed ambi-
■
ent temperature (see corresponding
product data sheet at the end of this
user manual).
Use the control element (2) to set the appli-
ance's inside temperature.
Select the right temperature based on the
wine. Further information on the optimum
storage temperature can be found in the sec-
tion „Maintaining quality" on page GB-14.
You can choose settings ranging from +4°C
to +22°C.
1. Press the SET function button (13) once .
The appliance will beep and the tempera-
ture indicator (14) light will begin to flash.
2. As long as the temperature indicator is
flashing, you can set the temperature.
Page GB-11
Werbung
Kapitel
Inhaltsverzeichnis
