Troubleshooting - IKEA MÖJLIG 202.371.48 Montage- Und Gebrauchsanleitug

ENGLISH
General information
Warning! Switch the appliance
off and let it cool down before
you clean it.
Warning! For safety reasons, do
not clean the appliance with
steam blasters or high-pressure
cleaners.
Warning! Do not use abrasive
cleaners, steel wool pads or
acids, they will damage the
appliance.
To remove any food remains wash the
enamelled elements, caps and crowns, with
warm soapy water.
Wash stainless steel elements with water.
and then dry with a soft cloth.

Troubleshooting

Warning! Refer to Safety
chapters.
What to do if...
Problem
There is no spark when light-
ning the gas.
The flame is blowing out im-
mediately after lightning.
This model is equipped with electrical
ignition, it is obtained through ceramic
"candle" with electrode. Keep them well
clean to avoid difficult lightning.
After cleaning, be sure to wipe dry with a
soft cloth.
Possible cause
There is no electrical supply.
There is no electrical supply.
Burner cap and crown are
placed incorrectly.
Thermocouple is not heated
enough.
The pan supports are not
dishwasher proof, they must be
washed by hand. After cleaning,
make sure that the pan supports
are correctly positioned.
Periodically ask the After Sales
Service to check the conditions of
the gas supply pipe and the
pressure adjuster, if it is fitted
(this service is not free of charge).
Remedy
Check that the unit is plug-
ged in and the electrical
supply is switched on.
Check the house electric in-
stallation fuse.
Check if the burner cap and
crown have been replaced
correctly, e.g. after cleaning.
After lightning the flame,
keep the knob pushed for
about 5 seconds.
11