Setting Up And Connecting The Appliance; Specifications Supplied; Technical Data; Installation Conditions - Gaggenau RW 404 Gebrauchs- Und Montageanleitung

Setting up and connecting the appliance

Specifications supplied

The appliance supplied consists of the following
components:
H Appliance for built in installation
H Ventilation grille
H Trim strips
H Dust filter
H Foam moulding for the ventilation ducting
H Spanner for adjusting the height of the appliance feet
H Bag containing fixing screws
H Cleaning cloth
H Instructions for installation and use
H Service record
H Information on energy consumption and noise
The ventilation grille and the trim strips are in the packing
at the front of the appliance.
After unpacking the appliance, check all parts for signs
of damage during transit. If you find any defects, contact
the retailer from whom you purchased the appliance or
our After sales Service.

Technical data

The appliance is interference suppressed in line with
EU Directive 2004/108/EC.
This product complies with the applicable safety require
ments for electrical appliances (EN 60335 2 24).
The refrigeration circuit has been checked for leak tight
ness.
Rating plate
The technical data of the appliance is printed on the
rating plate located inside the appliance on the left hand
side.

Installation conditions

Installation site
The ideal installation site is a dry, well ventilated room.
The appliance should not be installed in a position that
is exposed to direct sunlight or close to a source of heat,
such as a cooker or radiator.
If installation near to a source of heat is unavoidable,
use a suitable insulating panel or keep to the following
minimum distances from the source of heat:
H From an electric or gas cooker: 3 cm
H From an oil or solid fuel stove: 30 cm
The floor at the installation site must not sag.
Strengthen the floor if necessary.
29