Gaggenau RW 404 Gebrauchs- Und Montageanleitung Seite 36

9. Fit the ventilation grille in the kick panel.
10. Fit the kick panel onto the appliance.
The foam moulding is pushed into its final position
as you do so.
Important: the foam moulding should be resting
against the ventilation grille.
36
Electrical connection
The power outlet socket must be close to the appliance
and remain easily accessible after the appliance has
been installed.
Connect the appliance to a 220...240 V / 50 Hz AC
power supply from a correctly installed power outlet
socket. The power outlet socket must be protected by a
10...16 A fuse.
Do not use extension leads or multi socket adaptors.
In the case of appliances operated outside Europe,
check whether the voltage and type of current specified
10.
on the rating plate conform to the specifications of your
mains power grid.
If the power cord needs to be replaced, this must be
carried out only by an expert.
WARNING!
!
The appliance must not be connected to an electronic
energy saving plug (e.g. Ecoboy; Sava Plug) or an
inverter that converts direct current to 230 V alternating
current (e.g. solar energy systems, boat electrical
systems).
Before first use
9.
Before using the appliance for the first time, clean the
inside (see section Cleaning the appliance").
Before using the appliance for the first time, treat the
stainless steel surfaces of the door while cold by wiping
them down evenly in the direction of the grain using the
treatment cloth supplied. Previously used appliances
should be washed down first with hot water and a small
amount of washing up liquid.
After allowing the treatment to take effect for a short time,
wipe down the stainless steel surfaces of the door with a
dry, lint free cloth or kitchen roll. Repeat the treatment at
regular intervals.
You can obtain more treatment cloths from After sales
Service quoting article no. 00311134.