Radio Mode - Grundig RCD 5050 Bedienungsanleitung

RADIO MODE

Antenna
1
For the best FM reception, it is sufficient to
extend the telescopic antenna and direct it
accordingly.
Note:
If the FM signal is too strong, it is advisable
7
to push in the telescopic antenna.
Selecting the radio input source
1 Press »RADIO« button.
– Display: Briefly »FM«, then the frequency of
the radio station.
Tuning FM radio stations
Automatic station search
1 To activate the station search, press and hold
»PROG/MEM/INFO«.
– The device searches for up to 40 stations
with strong reception and stores them. After
the search has finished, you will hear the
station stored at preset 01.
Automatic station search
1
Activate the station search by keeping »
or » « pressed until the frequency display
9
changes to rapid run-through.
– The search stops when a station is found.
Manual search
1
To move the frequency forward in steps,
briefly press »
8
– The frequency changes in steps of 50 kHz.
19 ENGLISH
------------------------------------------------------------------------------------------------------------------------
« or » « several times.
9
Storing stations to presets
You can store FM radio stations on 40 presets.
1 Select the FM radio station with »
» « .
9
2
Press »PROG/MEM/INFO« briefly to
activate the memory function.
3
Select the desired station position with
»ALBUM+/MEM+/p« or
MEM–/o«.
4 Press »PROG/MEM/INFO« to save the
station.
5 To store more stations, repeat steps 1 to 4 as
described above.
Selecting stored stations
1
Select the station preset position with »p« or
»o«.
Stereo/mono reception
If the signal from the FM stereo station is weak,
you can improve the sound quality by switching
to mono reception.
1 »■ FM
Press
«
8
– Display: »MONO«.
2 »■ FM
Press
– Display: »STEREO«.
8
»ALBUM–/
MODE« to switch to mono.
MODE« to switch to stereo.
« or