Technical Data; Before Starting The Equipment; Operation - EINHELL 34.141.61 Originalbetriebsanleitung

Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Working width: ............................................38 cm
Cutting height: ................................... 13 – 38 mm
Dimensions (HxWxD) approx.: ..... 125x42x30 cm
Weight: ..........................................................9 kg

5. Before starting the equipment

Warning! Wear safety gloves whenever you carry
out any assembly or maintenance work.
Assembly
Fig. 3: Screw the push bar top section (12) to the
two longer ends of the push bar extensions (13).
Use two screws M6x35 (15) and two wing nuts
M6 (16) for this purpose. Using the holes (A) will
lengthen the push bar by approx. 6 cm.
Fig. 4: Screw the push bar bottom section (14) to
the two shorter ends of the push bar extensions
(13). Use four screws M6x35 (15) and four wing
nuts M6 (16) for this purpose.
Fig. 5: First hook one side of the push bar bottom
section (14) on the mower, then press the push
bar bottom section (14) together slightly and hook
the other side in place.
Fig. 5/6: To secure the push bar bottom section to
the mower, insert a split pin (17) into the hole (B)
on each side.
Hook the grass basket in place on the left and
right side of the roller (Fig. 8 / K). The grass box
must also be secured to the push bar using the
retainer belt (see Fig. 1). Adjust the retainer belt
according to your requirements.
Anl_GE_HM_38_S_F_SPK7.indb 16 Anl_GE_HM_38_S_F_SPK7.indb 16
GB

6. Operation

6.1 Setting the cutting height (Fig. 7)
Four diff erent cutting heights can be set between
a range of 13 – 38 mm. To do so, pull out the
spring-loaded bolts (C) on both sides and then
engage them in the required holes. The set cut-
ting height is indicated on the scale (E).
Note: The roller (F) must be aligned parallel with
the hand mower (spring-loaded bolts at same
height (C)).
6.2 Operation
The hand mower can cut grass up to approx. 10
cm in length. If you want your lawn to have a neat,
trimmed look to it, however, you must consistently
keep it cut down to a more manageable height.
When starting the mowing session (and when
mowing over freshly laid sod), it is advisable to
set the cutting height relatively high, then gra-
dually work your way down. For a well-groomed
look, the cutting height should be set to approx.
2.5 cm.
For optimum results, mow your lawn on a weekly
basis. Grass blades grow thicker, faster, and are
more resiliant when their stems are consistently
kept short (unless you live in very dry conditions
and do not frequently water). Always mow the
lawn when it is reasonable dry. In order to ensure
that your lawn has a clean, even look to it when
you're fi nished, mow in fairly straight paths at
walking pace. The cutting swaths should always
overlap each other by a few centimeters in order
to avoid unsightly strips of grass.
- 16 -
22.04.15 08:37 22.04.15 08:37