Installation; Unpacking And Positioning - Schneider SL 300C CB A++NF Bedienungsanleitung

3. Installation

3.1 Unpacking and positioning

WARNING! While unpacking, the packaging materials (polythene
bags, polystyrene pieces, etc.) should be kept away from children and
pets. CHOKING HAZARD! RISK OF INJURY!
1. Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2. Completely remove the transport-protection (adhesive tape) of the accessories.
Be very careful and do not use any aggressive or abrasive detergents to remove
residuals of the transport-protection.
3. Install the appliance in a suitable position with an adequate distance from
sources of heat and cold.
4. Install the appliance in a dry and well-ventilated place.
5. Protect the appliance from direct sunlight.
6. The doors must open completely and without hindrance.
7. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
8. Check that the appliance and the power cord are not damaged.
9. Connect the appliance to the mains properly.
10. The nameplate is situated inside the appliance or at the back.
Observe the possible (additional) lateral space requirement of the open door(s)
relevant to the door opening angle of the appliance.
Clockwise → down
A :
DJUSTABLE FEET
Anti-clockwise → up
41