Direct Dial-In - Disty distybase duo plus Bedienungsanleitung

3 Programming mode
Function
Line assignment
Calls to lines 1 and 2 are signalled on the analogue port.
Factory setting: 0
There is a limited feature set available on this analogue port primarally it
may only be connected to calls from or to the external trunk and may not
make internal calls. Because of this limited feature set the use of analogue
telephones is not recommended on this analogue port. If an analogue
desk phone is required use a Distybox with this system.
An active external connection can be taken over by any registered
#7
handset by dialling
subsriber.
An active connection on the handset can be handed over to the analogue
#7
port by dialling , the handset will receive positive acknowledge tone if
successful. In case the analogue port is busy the handset will receive
negative acknowledge tone and the connection will stay on the handset.
The analogue port never receives call waiting tone. Toggeling between
**0
lines by is not possible.

3.2.8 Direct dial-in

Function
Direct dial-in
Calls to lines 1 and 2 are signalled on the handsets according to the call
assignment.
Direct dial-in
Calls on the lines are accepted by the distybase duo/duo plus/duo exant,
the caller hears a signal tone and can trigger signalling on the relevant
handset after direct dialling the DTMF numbers 1...8. The analogue port
of distybase duo plus can be called by dialling 0.
Parameter
code
17
if the analogue port is not assigned as fax-
Parameter
code
21
21
13
Inputs
3 #
Inputs
0 #
1 #