Wall Mounting - Disty distybase duo plus Bedienungsanleitung

1
1
Selecting a The distybase duo/duo plus/duo exant is designed for wall mounting in
suitable interior rooms. Please note that the device must not be fitted in the
location immediate vicinity of any other electronic devices such as hi-fi systems,
office machines, satellite receivers or microwave ovens. This prevents any
interference between the devices. In addition, the device should not be
installed near heat sources (e.g. radiators or in direct sunlight). Do not
install the power supply at inaccessible location and do not cover it by
curtains etc.
Radio coverage The distybase duo/duo plus/duo exant must be able to establish a radio
link to the registered handsets. Before determining the final mounting
position, you should therefore check by using the field strength indicator
of a registered DECT handset that your desired location ensures the
optimum connection quality. The position of the aerial is a critical factor
here.
Owing to the digital transmission in the frequency range used, there may
be radiowave "blind spots" even within the specified range, depending on
the layout of the building. This results in a loss of transmission quality.
However, just a small change in position will often restore normal
transmission.

Wall mounting

Follow the steps given below to install the distybase duo/duo plus/
duo exant:
1. Drill two 6 mm diameter holes into the wall at a distance of 60 mm
2. Insert the rawlplugs and screw in the
3. Connect the external aerial to the
4. Connect your analogue device to the
Mounting
Mounting
apart.
screws until they protrude approx. 5 mm
clear of the wall.
appropriate socket (only distybase duo
exant).
analogue port (only distybase duo plus).
5
60 mm