2
Registering the handsets
2
Registering the handsets
The handsets need to be registered on the distybase duo/duo plus/
duo exant before they can be used.
Please note that no more than 8 handsets can be registered on the
distybase duo/duo plus/duo exant.
Proceed as follows to register the handsets:
1. Connect the AC adapter to your distybase duo/duo plus/duo exant.
Insert the AC adapter into a mains socket.
2. During the registration process, the handset should be located close
to the distybase duo/duo plus/duo exant or the connected aerial.
3. Start the registration procedure on the distybase duo/duo plus/
duo exant by pressing the Register button until the LED starts flashing.
4. Start the registration procedure on your handset. This process is
described in the operating instructions for your handset or your
distybox 300/5000. Use 0000 as the PIN or access code (AC).
5. The registration process is complete when the LED is off. The handset
is automatically assigned the next free internal phone number (from
1-8). If the registration process has not been successfully completed
within around 1 minute, repeat the process.
6. To register further handsets, repeat steps 2-5.
7