Technical Data - ATIKA ALF 2600 Originalbetriebsanleitung

Fault
Shredding material is not drawn
into the shredder
Shredding material not cut cleanly. Fixed counter blade not adequately
Device starts but blocks under as
slight load and switches off via
protective motor switch.
In case of further failures please contact our customer service.
Type / Model
Year of construction
Motor
Motor rating P S6 - 40 %
1
Motor rating P S1
1
Rotational speed cutting roller
ON/OFF-switch with
Weight
Sound pressure level at work L
(measured to 2000/14/EC)
Measured sound power level L
(measured to 2000/14/EC)
Guaranteed sound power level L
(measured to 2000/14/EC)
Max. branch diameter
(only for freshly cut wood)
Safety class
Protection class
Mains fuse
Operating mode:
S1
Continuous operation
18
Possible cause
Cutting roller worn
adjusted.
Extension cable too long or cross-
section to small.
Socket too far from mains supply and
cross-section of mains cable too small.

Technical data

PA
WA
WA
S 6 – 40 %
Continuous intermittent operation
For 10 min.:
4 min. continuous operation
6 min. operation at no or low load
Remedy
Adjust fixed counter blade as described under „ad-
justing the fixed counter blade". In case of severe
wear, replace cutting roller.
Have the cutting roller replaced by the customer
service.
Adjust fixed counter blade.
Extension cable at least 1.5 mm², maximum 25 m
long. If a longer cable is used, minimum cross-
section 2.5 mm².
AC-Motor 230 V~, 50 Hz, 2800 rpm
overload protection; cutting and reverse function, zero-voltage initiator
16 A time-lag
ALF 2600
see last page
2600 W
2000 W
40 min
-1
28 kg
79.8 dB (A)
88.6 dB (A)
K = 3 dB (A)
89 dB (A)
∅ max. 40 mm
I
IP X4