Limitations Of Use - TEUFELBERGER treeMOTION Gebrauchsanleitung

for fall arrest. No fall- arrest harness!
pic. 15
Replacement rope bridge (Part no. 7333212)
If the green mantle is ruptured by any means (e.g.
cutting, heating or abrasion) or a tactile inspection
of the kern identifies changes in diameter or rope
properties, the rope bridge shall be replaced imme-
diately by, or under the supervision of, a competent
person.
For replacement, it is imperative that you use only
the replacement part approved by the manufacturer.
Before using the equipment again, be sure to verify
that the spare part has been replaced correctly.
If you lack the experience, skills, and knowledge
that are necessary for this job, please consult a
compentent person or the manufacturer.
Additional tests were carried out at TÜV with DMM
small Axis swivel-SW 100 used on the rope bridge
instead of the green ring. The quoted swivel may
therefore be used as an alternative option.
pic. 17
pic. 16
4.4. MOUNTING OF REPLACEMENT PARTS
Mounting of gear loops (included) on your tree-
MOTION / treeMOTION S.light
pic. 18
2) Pass shock cord through base material of har-
ness. Tie stopper knot in one end of the shock cord,
leaving approx. 1 cm looking out of the end of the
knot. Cut the other end.
3) Tie stopper knot in the other end of the shock
cord. In this way you can customize your harness by
installing gear loops anywhere between two holes of
the base material of the back pad or the leg loops.

5. LIMITATIONS OF USE

treeMOTION / treeMOTION S.light may not be
used in fall arrest situations. Slack in the climbing
line should be minimised at all times. There must
not be any chance of a free fall. „Free fall" does,
however, not mean e.g. slipping of the user´s feet.
Be aware of the potential for pendulum swings and
manage the risk.
Choose the connection of the harness to an an-
chorage point at a level which will result in the least
total fall distance consistent with the user's ability
to carry out work tasks.
RepLacement paRts
1) Cut tubing to required
lengths. Insert shock
cord.
pic. 19
pic. 20
11