Sygonix 1423059 Bedienungsanleitung Seite 28

Proceed as follows to select an operating mode:
Read the operating instructions of your DVR to check which operating mode it sup-
ports (only conventional "CVBS" video signal, or a high-resolution signal according to
the "AHD", "CVI" or "TVI" standards).
Depending on the available operating mode, you may need to activate it first in the
OSD menu of your DVR.
Only when the operating mode of the DVR matches the operating mode of the surveil-
lance camera will a picture appear later as well.
• Connect the surveillance camera to the external power supply and your DVR as described in
chapter 7.
• Select the correct input on the DVR.
You may now see no picture or only interferences, such as stripes running through.
• Move the control lever in one of the four directions and hold it there for at least 5 seconds to
select the desired operating mode.
"CVBS" Move control lever towards "R"
"AHD" Move control lever towards "UP"
"CVI" Move control lever towards "DOWN"
"TVI" Move control lever towards "L"
• The surveillance camera will switch the operating mode after the end of 5 seconds. Release
the control lever.
• The new operating mode is now saved.
Important!
If you want to choose another operating mode, you need to interrupt the power supply
for a few seconds for reasons of safety and then reconnect it.
Then proceed as described above to switch the operating mode again.
28