Valeo MINISPHERE 100 Betriebsanweisung Seite 32

Control elements and display
2.2.6. Switch on the heating (SC410 HAC, HVAC only)
NOTE:
The heater turns on automatically when the set temperature is
undershot by 2 K.
2.2.7. Toggle between fresh and circulating air (SC410 VAC,
HVAC only)
Press button to toggle between fresh and circulating air.
If the LED light above the button lights, the circulating air mode is active,
the fresh air supply is turned off (Fig. 15).
Fig. 15: SC410 Circulating air mode is active
If the LED light does not light, the fresh air flaps are open (Fig. 16).
28
Fig. 16: SC410 Fresh air mode active
NOTE:
If the air-conditioning unit is active, the fresh air flaps are closed by
default. When the heating function is activated, the fresh air flaps are
open.
By pressing the fresh air / circulating air button this setting can be
changed manually. After 10 minutes, the system returns to the default
state.
In heating mode, rapid heating is achieved when the circulating air but-
ton is activated (-> fresh air flap closed).
Fogging of the vehicle windows is thereby possible.
2.2.8. Malfunctions
NOTE:
If errors occur, the display will alternate between the set temperature
and the error codes.
The setpoint temperature is displayed for 5 seconds and then sequen-
Minisphere 100/130