CO/Tech 18-1483 Bedienungsanleitung Seite 6

Assembly
• Assemble the infrared heater outdoors
or in a large room with min. 1 m from
flammable objects such as branches,
furniture, curtains, etc.
• Do not mount the heater directly under
or over a power point.
• The appliance must be mounted with
a min. of 1.8 m from walls and min.
50 cm from a ceiling or nearest wall.
1. Screw the bracket to the wall using
suitable screws and wall plugs for
the wall material to ensure that it
securely anchored.
Note: Use all four holes in the bracket
and make sure that the bracket is
angled up according to the picture.
2. Loosen the 2 × M6 screws (at the arrow
on the picture) that attach the infrared
heater to the bracket.
3. Angle the infrared heater towards
the area where the heat is required and
tighten the screws.
Instructions for use
1. Connect the plug to an earthed wall socket.
2. Set the function switch (5) to the ON position. The infrared heater is in standby
mode and the indicator light (10) shines red.
3. Press [ ] (6) on the remote control or press [
the infrared heater. The red indicator lamp (9) is on.
4. Press any of the buttons [
5. Set the function switch (5) to the OFF position to turn the infrared heater off.
6. Unplug the appliance when it is not in use.
] (8) on the display to start
] to return to standby mode.
6