Operation; Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - EINHELL DSE 125 Originalbetriebsanleitung

•
Check that the sanding/grinding plate is se-
cure.
5.4 Fastening the abrasive paper
The Velcro fastener enables easy changing of
sanding/grinding paper. Make sure that the va-
cuum extraction holes on the sanding/grinding
paper and the sanding/grinding disk are aligned.

6. Operation

6.1 Connecting to a compressed-air supply
•
Connect the nipple (5) to the quick-lock cou-
pling of a compressed-air hose (the hose is
not supplied).
•
Note the maximum permissible operating
pressure of the equipment.
6.2 Switching On/Off (Fig. 1)
To switch on: Depress the operating switch (2)
To switch off : Let go of the operating switch (2)
6.3 Setting the speed (Fig. 1)
The equipment speed can be controlled:
•
The control lever (3) points towards the ext-
ractor adapter (1): maximum speed.
•
The control lever points away from the extrac-
tor adapter (1): reduced speed.
•
Check the speed setting before carrying out
any work on the workpiece.
6.4 Working with the eccentric sander/grinder
Important! The workpiece you want to sand/grind
must never be held in your hand. Secure the
workpiece on a sturdy surface or with a vise.
•
Place the whole surface area of the sanding/
grinding disk on the material.
•
Switch on the machine and move it with gent-
le pressure over the workpiece, making circu-
lar or transverse and linear movements.
•
Use a coarse grit for coarse sanding and a
finer grit for finish sanding. You can find the
best grit size for the job by carrying out san-
ding/grinding tests.
Important!
The dusts which are formed while the equipment
is being used may be a health hazard:
•
Always wear safety goggles and a dust mask
during sanding/grinding work.
•
All persons who work with the equipment or
Anl_DSE_125_SPK7.indb 16 Anl_DSE_125_SPK7.indb 16
GB
enter the workplace must wear a protective
dust mask.
•
Eating, drinking and smoking are prohibited
at the workplace.
•
Paints containing lead are not allowed to be
used!
7. Cleaning, maintenance and
ordering of spare parts
Disconnect the compressed-air supply from the
equipment before performing any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend that you clean the equipment
immediately after you use it.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may be ag-
gressive to the plastic parts in the equipment.
Ensure that no water can get into the interior
of the equipment.
7.2 Maintenance
There are no other parts inside the equipment
which require maintenance.
7.3 Ordering spare parts
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Defective components must be dispo-
sed of as special waste. Ask your dealer or your
local council.
- 16 -
18.07.12 11:06 18.07.12 11:06