Technical Data; Before Starting The Equipment - EINHELL DSE 125 Originalbetriebsanleitung

4. Technical data

Max. working pressure: ............................ 6.3 bar
Air consumption: .....................(6.3 bar) 106 l/min
Vibrations: ................................... 0 – 10500 min
Weight: ..........................................................1 kg
Eccentric sanding/grinding plate:
Sanding/grinding area: ........................Ø 125 mm
Abrasive paper size: ............................Ø 125 mm
Sound and vibration
Sound and vibration values were measured in
accordance with EN ISO 15744.
Sound pressure level L
Uncertainty K ............................................. 3 dB
pA
Sound power level L .......................... 106 dB(A)
WA
Uncertainty K ............................................. 3 dB
WA
Wear earmuff s.
The impact of noise can cause damage to
hearing.
Total vibration values (vector sum of three direc-
tions) were determined in accordance with
EN ISO 28927-3.
Vibration emission value ah = 9.1 m/s
Uncertainty K = 1.5 m/s
Warning!
The specifi ed vibration value was determined in
accordance with a standardized testing method.
It may change according to how the equipment
is used and may be higher in exceptional circum-
stances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Reduce noise generation and vibration to a
minimum!
•
Use only equipment that is in perfect condi-
tion.
•
Maintain and clean the equipment regularly.
•
Adapt your way of working to the equipment.
•
Do not overload the equipment.
•
Have the equipment checked if necessary.
Anl_DSE_125_SPK7.indb 15 Anl_DSE_125_SPK7.indb 15
GB
-1
........................ 95 dB(A)
pA
2
2
- 15 -
•
Switch off the equipment when not in use.
•
Wear gloves.
Residual risks
Even if you use this compressed-air tool in
accordance with the instructions, certain
residual risks cannot be eliminated. The fol-
lowing hazards may arise in connection with
the equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is applied.
3. Health damage caused by hand-arm vibra-
tions if the equipment is used over a longer
period or is not properly guided and maintai-
ned.

5. Before starting the equipment

Before you connect the equipment to the power
supply, make sure that the data on the rating plate
are identical to those of the supply voltage.
Disconnect the compressed-air supply be-
fore performing any cleaning, adjusting and
maintenance work.
5.1 Lubricating the tool
Each time before starting and during prolonged
operation:
•
Insert 3-6 drops of special compressed-air oil
into the compressed-air connection (5)
•
Let the equipment run briefly so that any sur-
plus oil is blown out.
5.2 Fitting the dust extractor adapter
(Figure 6)
Connect the dust extractor adapter to a suitable
dust extraction system.
Important!
For health safety reasons it is imperative that you
use a dust container or a dust extraction system.
5.3 Fitting/removing the sanding/grinding
plate (Fig. 5)
•
Place the open-ended wrench (7) between
the sanding/grinding plate (6) and the
housing,
•
Undo the sanding/grinding plate by turning.
•
Fit a new sanding/grinding plate in reverse
order.
•
Remove the open-ended wrench.
18.07.12 11:06 18.07.12 11:06