Connecting The Power Cord To The Ac Outlet - JVC PD-35D30ES Bedienungsanleitung

Connecting the power cord to the AC
outlet
Insert the AC plugs on the power cords from the TV and
receiver into AC outlets.
Caution
• Operate only from the power source specified (AC 110
– 240 V, 50/60 Hz) on the unit.
• Failure to use the supplied power cord or to insert it
into a correctly earthed outlet may result in electric
shocks.
Use the supplied power cord which best suits the area in
which you live.
Attaching the ferrite cores
Attach ferrite cores to the power cord.
Using the power cord without ferrite cores may lead to
noise (interference).
Open the ferrite core, insert the power cord and close the
ferrite core.
Attach a ferrite core to each end of the power cord.
Ferrite core
Power cord
Supplied ferrite cores
Supplied ferrite cores
Supplied ferrite cores
Back of the TV
AC INLET
Power cord
Insert the AC plug into a correctly earthed outlet.
The receiver power lamp lights red, and the receiver is in
the standby mode, when the AC plug on the power cord is
connected to an AC outlet.
• Remove the AC plug from the outlet to completely
disconnect the TV from the power supply.
Power cord
AC INLET
AC110-240V
Back of the receiver
Receiver rear
1
EXT-
2
EXT-
S
1 Aerial socket (page 12)
2 EXT-1 terminal (pages 12, 31, 41)
3 EXT-2 terminal (pages 12, 15, 31, 41)
4 EXT-3 terminal (pages 31, 41)
5 EXT-4 terminal (pages 31, 41)
6 AUDIO OUT terminal (page 42)
7 DISPLAY OUT terminal (page 11)
8 AC INLET (page 13)
Connections
3 DISPLAY OUT
EXT-
S
L
R
Pr Pb Y
4
EXT- AUDIO OUT
R L
AC110-240V
13